Axis 292 Uživatelský manuál stáhnout pdf (Strana 8)

Page 8 AXIS 292 Installation Guide

Manual Installation using ARP and Ping in Windows

Assign a unique IP address to the AXIS product using a computer on your network as follows:

1. Acquire an unused IP address for the AXIS 292 from the network administrator. The

AXIS 292 must be installed on the same subnet as the computer.

2. Connect a standard network cable from the AXIS 292 to the network.

3. Locate the serial number/MAC Address (S/N) on the label on the underside of the AXIS

292.

4. From a computer on the network, open a Command Prompt, i.e. from the Windows Start

menu, select Run... and type command or cmd in the field. Click OK.

5. Enter the commands:

Syntax:

Example

6. Connect power to the AXIS 292.

7. When ‘Reply from 192.168.0.125: ...’ is displayed (approximately 10-15 seconds), type

Ctrl+C to close the ARP Ping session.

8. Start a Web browser, enter the IP address in the Address/Location field and Press Enter.

9. Enter a password for the root user (administrator). See Setting the password, on page 6.

10. The installation is now complete. Proceed to Accessing the AXIS 292, on page 10.

Note:

If the password is lost, the AXIS 292 must be reset to the default settings. Refer to Factory

default settings, on page 11, for instructions.

arp -s <IP address> <MAC address>

ping -l 408 -t <IP address>

Note: The ping command is

followed by -l (lower case L)

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 53 54

Žádné komentáře

Axis 292 Uživatelský manuál Strana 8