Axis AXIS USB Manuál s instrukcemi stáhnout pdf (Strana 52)

The EStop is enabled by operating the main menu “Config”->”Ports and Pins”,

clicking on page ”Input Signals” and putting a green tick on EStop’s “Enabled”

column. “Port #”, “Pin Number” and “Active Low” should be set according to

physical connections (referring to chapter “Shape and Connections”, section

“Control Inputs”). If the input is low level effective, put a green tick in “Active Low”

column. Then click “Apply” and “OK” to save the settings.

When EStop is trigged, the GCode execution is stopped. If 2 PWM outputs also

required to stop, put “X” on “PWM1=0 on EStop” and “PWM2=0 on EStop” in

“HyCNC-4P Config” window. The “HyCNC-4P Config” window can be shown by

operating the main menu “Config”->”Config PlugIns”.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 67 68

Žádné komentáře

Axis AXIS USB Manuál s instrukcemi Strana 52