Axis A1001 Uživatelský manuál

To start over the configuration, add a user first. Enter the basic information for this user. If needed, valid duration can be configured here. If t

For certain identification types, scheduling is required. In the controller system there are three default schedules which are Always, Office Hours,

At least a user, a door, and a schedule are required to be applied to a group. From the configured group above, a statement can be read. Group membe

Chapter Chapter 3: Install Axis A1001 in Synology Surveillance Station 7.0 Axis Door Controller A1001 is an add-on which is not pre-enabled in Survei

Axis A1001 needs to be synchronized with an NTP server to make sure the time is exactly correct. Also, each door configured in Surveillance Station

Cardholders: to edit the cardholders which have been created in Axis A1001. Log Center: to record event logs that are related to the door controller.

To avoid potential risks, privilege settings for access control is also configurable here. For those users in Surveillance Station, it is not necess

Administrators can of course delete a certain user; however, that specific user needs to be registered again in Axis A1001. Block function offers the

3.3 Log Center Log Center integrates all the event logs including the manual lock / unlock, cardholder block and all relevant events generated by Axi

3.4 Advanced In the Advanced tab, events are separated into two different columns, which are Log Event and Log Alarm. Some of the events are locked

Table of Contents Chapter 1: Introduction ... 3 1.1 What

Chapter Chapter 4: Use Synology Door Monitor with Axis A1001 There are two different ways to implement the door monitor in Surveillance Station with

4.2 Desktop Shortcuts Thanks to the desktop design in Surveillance Station 7, door units can be created as shortcuts on the desktop for easier manage

However, if administrators wish to check the door status within Live View, a door unit can be dragged and dropped into a separated Live View layout.

4.5 Door Units on E-map Door units can be seen on the e-map as well. Surveillance Station offers three different statuses so that administrators can

Chapter Chapt er 5: More Applications Axis Door Controller in Surveillance Station can be implemented with other useful applications such as Action

5.2 Notification Surveillance Station supports push notifications via SMS, E-mail, and Synology mobile application DS cam. Notification supports dif

Chapter Chapter 6: Axis A1001 Note Credentials within Axis A1001 can be up to 15,000 of third-party access management software depending on server ca

Chapter Chapter 1: Introduction 1.1 What Is Access Control? In the era of networking exploration, most of the electronic devices are being connected

1.2 Why Does Axis A1001 Work Better with Synology Surveillance Station? The rudiment of integrating Axis A1001 into Surveillance Station is the comb

Chapter Chapter 2: Configure Axis A1001 before Installation Axis Door Controller A1001 is a network controller with multiple I/O ports embedded that

In the Overview page, basic information such as IP address and firmware version are stated here. However, the statements highlighted in red inform yo

Assuming that there is only one door that needs to be configured, enter the name and select the number of doors that need to be configured here. In

When it comes to the reader configurations, it depends on the devices that would be used at the entrance and exit. For example, if a company is using

The Hardware Pin Chart is a reference for the actual connections of all the analog devices such as card readers, door lock, lock monitor, and some ot