Axis APPINT Uživatelský manuál stáhnout pdf (Strana 37)

LNC-M8000

Function

寶元數控精密股份有限公司 213

LNC Technology Co., Ltd.

W_TOOL_DATA(PATH,Tool_No,TYPE,VALUE)

Write INT Tool Info

Description

 PATH =>Path No., value range 0 ~6, unit：N/A.

0：Current path, 1~6：First path~6th path.

 Tool_No =>Appoint write tool info’s tool number, value range1 ~ 400, unit：N/A

 TYPE =>Appoint write tool info’s type, value range****, unit=below

2: Tool wear diameter

3: Tool geometry diameter

101 ~ 132: Tool wear length 1~32 axis

201 ~ 232: Tool geometry length 1~32 axis

 VALUE =>Write info, value range double, unit=mm

Alarm：

-1 => Appoint tool number is over range

Example

W_TOOL_DATA(0,2,201,1.234); /* this path Tool 2 first axis geometry tool length=1.234mm */

8.8 I LATCH value function

W_I_LATCH(PATH,I_NO,HwifAxis_No,Ri_Fa)

Setup I Latch

Description

This function will stop interpretation automatically.(TypeⅠ)

 PATH =>Path No., value range 0 ~6, unit：N/A.

0：Current path, 1~6：First path~6th path.

 I_NO => I No., value range****, unit：N/A

1~2 Card1 EPCIO LI1~2

11~12 Card2 EPCIO LI1~2 ~ 51~52 Card6 EPCIO LI1~2

101~106 Card1 CPLD LI1~6

111~116 Card2 CPLD LI1~6 ~ 151~156 Card6 CPLD LI1~6

 HwifAxis_No=>Hardware axis No., value range****, unit：N/A

1~6:Card1

11~16:Card2 ~ 51~56:Card6

 Ri_Fa=>1:Rising Edge,2:Falling edge, value range1~2, unit：N/A

：N/A

Example

W_I_LATCH(0,101,1,1); /* Enable CPLD first I point, first axis at hardware, up trigger */

R_I_LATCH(PATH,I_NO)

Get if I Latch happend

Description

This function will stop interpretation automatically.(TypeⅠ)

 PATH =>Path No., value range 0 ~6, unit：N/A.

0：Current path, 1~6：First path~6th path.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 59 60

Komentáře k této Příručce

Žádné komentáře

Axis APPINT Uživatelský manuál Strana 37

Komentáře k této Příručce

Související produkty a manuály pro Servery Axis APPINT